With the new bearings, piston rings and seals fitted into the 850 block (at last), it was time to pull the old 700cc engine from the Vegemite Special so certain other parts could be swapped over. Firs

Refreshing our Dunstall Honda CB750’s forks should be straightforward, but ends up involving precision machining and much profanity. Alan reports from the end of his tether

IN MY JOB as a freelance photographer, I’d been on the 2012 press launch of the L405 Range Rover in Morocco, where ‘Mr Land Rover’, Roger Crathorne, had brought over a couple of original 1970 Velar pr

…from a world champion mechanic. Yamaha spanner ace Liam Coffey reveals all

Rick’s reaching the finishing stages with the Bradbury project, but needs to make some parts himself and adjust others to maintain progress. Bring on the lathe and the milling machine…

Pick up the phone, call your local railway, offer to volunteer, and it could be the start of a whole new adventure, says ALEX ALDER. You might even go the whole hog and buy an engine…